|
|
|
Main Message Board >
Building 6BR Repeater for High Power...
Building 6BR Repeater for High Power...
< Check out the NEW Turkey SHOOT Contest!
Page:
1
redfeather
2 posts
Sep 29, 2004
5:46 PM
|
I am currently building an XTC high power rifle using the tubegun kit see link below. To use the kit you must have a short action rem. 700 action, and from there just put it together. I am using a Kreiger 1-12 twist barrel already chambered for 6BR, but I will have to have a reamer run inside because I want a .272 neck to not have to turn necks. Here is the Tube Gun Kit link http://www.tubegun.net/ check it out because it is a great alternative to other similiar rifles that cost three times as much. Thanks-Major redfeather.
|
Moderator
62 posts
Sep 29, 2004
10:22 PM
|
This thread was previously posted in the reloading forum. It fits better in the main message boards and the posts were identical, so they have been consolidated here. DANTEC replied:
no need 0.272 for NO turn neck , I use 0.271 ( original Norma drawing ) and that work perhaps 0.270 works too if you check ammo before chambering .
REM 700 need /MUST be blue print if you doesn t want to have funny groups
good shooting
DAN TEC
|
Post a Message
|
|
